Beschreibung
ABS Module Pump for BMW E38 – OEM Part Number 1164241
This is a genuine OEM ABS module pump removed from a fully running BMW E38 vehicle. The unit carries part number 1164241 and has been professionally tested to confirm correct operation before listing. This is a factory-original component, not an aftermarket replacement, ensuring seamless compatibility with the E38’s original braking architecture.
The ABS module pump controls hydraulic pressure distribution across the braking system and communicates directly with the vehicle’s electronic control network. A faulty or failing unit commonly triggers ABS warning lights, brake pressure faults, or loss of electronic braking function. Replacing it with a genuine tested OEM unit is the most reliable solution.
The part is in good used condition. The housing shows no cracks or corrosion, electrical connectors are undamaged, and all mounting points remain fully intact. What you receive is a clean, ready-to-fit unit pulled from a donor vehicle in working order.
Professional installation is strongly recommended. Depending on your vehicle’s configuration, coding or adaptation may be required after fitting. Always confirm the OEM part number and compatibility with your specific E38 variant before purchase.
Rücksendungen werden nur bei tatsächlichen Mängeln akzeptiert – defekt bei Erhalt, nicht wie beschrieben oder falsches Teil geliefert – und müssen innerhalb von 14 Tagen beantragt werden, wobei alle 3 Manipulationsschutz-Aufkleber intakt sein müssen. Keine Rücksendungen aufgrund von Meinungsänderungen, fehlerhafter Installation, Codierung/Programmierung oder Kompatibilitätsfehlern seitens des Käufers; die Überprüfung der Kompatibilität (OEM-Nummer, Firmware, Fahrzeug) liegt in der Verantwortung des Käufers. Vollständige Rückgabebedingungen: https://giantparts.eu/refund-and-returns/
